Excerpts from the CD-ROM:
THE COMPLETE MICROWAVE OVEN SERVICE HANDBOOK: Operation, Maintenance, Troubleshooting and Repair

Copyright © 1989-2013 J. Carlton Gallawa . All Rights Reserved Worldwide

(Excerpt)

18.6 FAILURE CODES AND SERVICE PROCEDURES

Many newer models use a system of failure codes to warn of certain specific problems or conditions. Following are the failure codes and symptoms for a number of different models. The codes and symptoms are listed along with the explanation, possible cause and respective repair procedure(s).

(Excerpt)
MAGNETRON SERVICE TEST MODE
AMANA Commercial Ovens Including RC16MP, RC17, RC2OA, RC22, RC22MP, RC22MPS, RC22S, RC27, DQ22HS, MC22MP and MC22MPT Models

Enter the Service Test Mode as follows:
1. Open door.
2. Press DELETE.
3. Press pads 1, 3, 5, 7.
4. Close door.
5. Press DELETE within 15 seconds (Pressing RESET at any time will cancel the Service Test)

 

(Excerpt)

The following chart applies to the following COMMERCIAL models:

PANASONIC

  • NE-1780R
  • NE-2680R
  • NE-1880
  • NE-2780
  • HOBART

  • HM1600
  • DISPLAY DESCRIPTION EXPLANATION INFORMATION
    F33 Open (exhaust) temperature sensor 1. Temperature sensor failure
    2. Digital programmer circuit (DPC) failure
    3. Loose connector or bad solder joint at CN5
    Code appears when the failure occurs
    F44 Shorted keypad   Code appears 2 minutes after failure occurs
    NO DISPLAY 1.25A fuse open Defective low-voltage transformer  
    NO DISPLAY 1.25A fuse intact 1. Thermal cut-out tripped
    2. Defective low-voltage transformer
    3. Defective DPC board
     
    F81 No voltage to lower-left HV transformer 1. Defective Relay, RY-3 (A)
    2. Loose connector or bad solder joint at CN256, CN257
    3. Malfunctioning DPC
    Code appears when failure occurs
    F82 No voltage to lower-right HV transformer 1. Defective Relay, RY-5 (B)
    2. Loose connector or bad solder joint at CN258, CN259
    3. Malfunctioning DPC
    Code appears when failure occurs
    F83 No voltage to upper-left HV transformer 1. Defective Relay, RY-7 (C)
    2. Loose connector or bad solder joint at CN260, CN261
    3. Malfunctioning DPC
    Code appears when failure occurs
    F84 No voltage to upper-right HV transformer 1. Defective Relay, RY-9 (D)
    2. Loose connector or bad solder joint at CN262, CN263
    3. Malfunctioning DPC
    Code appears when failure occurs
    F86 Shorted contacts of RY-3 1. Defective Relay, RY-3 (A)
    2. Malfunctioning DPC
    Code appears when failure occurs

     

     

    BACK | HOME | ABOUT THIS CD-ROM | ABOUT THE AUTHOR | PREVIOUS PAGE

    Copyright © 1989-2013 J. Carlton Gallawa . All Rights Reserved Worldwide